Back / Intermediate / Compound (multi-joint)

Reverse Grip Bent-Over Rows

A barbell exercise for the upper back, with the biceps, lats and rear delts assisting.

At a glance

Primary

Upper back (rhomboids, mid/lower traps)

Secondary

Biceps, Lats, Rear delts, Forearms & grip

Equipment

Barbell

Movement pattern

Row, Shoulder-blade squeeze

Level

Intermediate

Type

Back, Compound (multi-joint)

Loads the lower back. Use a load you can control and skip it if it causes pain.

How to do it

1. Stand erect while holding a barbell with a supinated grip (palms facing up).
2. Bend your knees slightly and bring your torso forward, by bending at the waist, while keeping the back straight until it is almost parallel to the floor. Tip: Make sure that you keep the head up. The barbell should hang directly in front of you as your arms hang perpendicular to the floor and your torso. This is your starting position.
3. While keeping the torso stationary, lift the barbell as you breathe out, keeping the elbows close to the body and not doing any force with the forearm other than holding the weights. On the top contracted position, squeeze the back muscles and hold for a second.
4. Slowly lower the weight again to the starting position as you inhale.
5. Repeat for the recommended amount of repetitions.

Common mistakes

• ✗ Rounding the lower back while bent over.

  Why it hurts: Holding a hinge with a flexed spine under load strains the lower back, especially as you tire.

  ✓ Instead: Hinge with a neutral spine and braced core. If you cannot hold it, switch to a chest-supported row.

• ✗ Standing up and jerking the weight.

  Why it hurts: The torso swings on every rep and the lower back takes repeated jolts.

  ✓ Instead: Keep the torso angle fixed and choose a load you can row without body English.

Open in the appGet started